Instructions
Table of Contents
Floor Mats
Floor Mats Video
Floor Mats Instructions
- Installation:
- Remove any existing floor mats from the car.
- Place the universal trim-to-fit car floor mat on the driver's side.
- Adjust the mat to align with the contours of the car floor.
- Secure the mat in place using the provided hooks or fasteners.
- Repeat the same steps for the passenger's side and rear mats.
- Trimming:
- If necessary, trim the edges of the floor mat to fit perfectly.
- Use a sharp utility knife or scissors to carefully cut along the marked lines.
- Double-check the fit and make additional trims if needed.
- Care Instructions:
- Regularly remove the floor mats for cleaning.
- Shake off loose dirt and debris.
- Use a mild detergent and water solution to scrub the mats.
- Rinse thoroughly with clean water.
- Air dry the mats completely before placing them back in the car.
- Avoid using harsh chemicals or abrasive cleaning tools.
Seat Covers
Seat Covers Video
Seat Covers Instructions
- Installation:
- Remove the headrests from the car seats.
- Slide the universal car seat cover over the seat backrest.
- Stretch the cover over the seat cushion, ensuring a snug fit.
- Adjust the cover to align with the seat contours.
- Reattach the headrests securely.
- Repeat the same steps for other seats in the car.
- Trimming:
- If necessary, trim any excess fabric from the seat cover.
- Use sharp scissors to carefully cut along the marked lines.
- Ensure even and clean edges after trimming.
- Care Instructions:
- Regularly remove the seat covers for cleaning.
- Check the care instructions provided by the manufacturer.
- For machine washable covers, use a gentle cycle with cold water.
- Air dry the covers or tumble dry on low heat.
- Avoid using bleach or harsh detergents.
- For leather or specialized covers, follow specific care guidelines.
Hubcaps
Hubcaps Video
Hubcaps Instructions
- Installation:
- Make sure the wheel is clean and free of dirt or debris.
- Align the hubcap with the wheel's center.
- Press the hubcap firmly onto the wheel, starting from one side.
- Continue pressing until the hubcap snaps into place.
- Repeat the same steps for the remaining hubcaps.
- Double-check that all hubcaps are securely attached.
- Care Instructions:
- Regularly clean the hubcaps to maintain their appearance.
- Use mild soap and water to remove dirt or grime.
- Avoid using harsh chemicals or abrasive cleaning agents.
- Gently wipe the hubcaps dry with a soft, non-abrasive cloth.
- Inspect the hubcaps for any damage or cracks.
- Replace damaged hubcaps as needed.